Search results for "Mass distribution"
showing 10 items of 290 documents
Chemometric Study on Alkaline Pre-treatments of Wood Chips Prior to Pulping
2016
Alkaline pre-treatments were performed for the production of organics-containing effluents from silver/white birch (Betula pendula/pubescens) and Scots pine (Pinus sylvestris) chips prior to chemical pulping. Pre-treatment conditions were varied with respect to time (from 30 min to 120 min), temperature (130 °C and 150 °C), and alkali charge (1, 2, 3, 4, 6, and 8% of NaOH on oven-dried wood). The analytical data (total content, weight average molar mass, and molar mass distribution) on dissolved lignin were subjected to principal component analysis to examine the relationship between molar mass and molar mass distributions in lignin removed from different wood species under varying alkaline…
Mechanism of Anionic Polymerization of (Meth)acrylates in the Presence of Aluminum Alkyls, 6. Polymerization of Primary and Tertiary Acrylates
1998
The kinetics of the polymerization of n-butyl acrylate initiated by lithiated ester enolates in the presence of aluminum alkyls was investigated in toluene and in toluene/Lewis base mixed solvents at −78 °C. In pure toluene, curved time−conversion plots, incomplete monomer conversion, and broad molecular weight distributions (Mw/Mn ≈ 2) are observedin the absence of aluminum alkyls the molecular weight distributions are significantly broader (Mw/Mn > 14). High monomer conversions and narrower molecular weight distributions (Mw/Mn ≈ 1.5) are obtained when using Lewis bases (e.g., methyl pivalate) as cosolvents. The polymerization of tert-butyl acrylate rapidly reaches full monomer conversion…
Kinetics and mechanism of group transfer polymerization of N-butyl acrylate catalyzed by Hgl2 /(CH3 )3 Sil in toluene
1994
The group transfer polymerization (GTP) of n-butyl acrylate (nBuA) using 1-methoxy-1-(trimethylsiloxy)-2-methyl-1-propene (MTS) as an initiator, mercuric iodide (HgI2) as a catalyst in toluene at room temperature gives a very good control of molecular weight and narrow molecular weight distribution. (Mw/Mn < 1.2). Kinetic studies in this system reveal that this reaction is rather slow, half-lives being in the range of hours. The kinetic order of the apparent rate constant of propagation with respect to initiator and catalyst concentrations were found to be near to unity. However, the first-order time-conversion plots exhibit considerable induction periods. Upon addition of trimethylsilyl io…
Adsorptionseffekte als Fehlerquellen bei Lichtzerstreuungsmessungen
1956
Es werden die Einflusse der Adsorption von Hochpolymeren aus den Losungen auf Lichtzerstreuungsmessungen untersucht. Zunachst wird die Adsorption aus Losung an Glaswolle und Glaspulver in verschiedenen Losungsmitteln gemessen. Es zeigt sich, das sowohl Konzentrationserniedrigung, bestimmt im Differentialrefraktometer, wie auch eine Abnahme des Molekulargewichtes, aus der Lichtzerstreuung bestimmt, infolge selektiver Adsorption auftreten. Beim Schutteln der Losungen tritt als weiterer Effekt ein Abbau der Kettenmolekule ein. Beim Filtrieren von Losungen nehmen durch Adsorption im Filter Konzentration und Molekulargewicht ab. Die Abnahme wachst mit der Feinheit des Filters, d. h. mit seiner O…
Accelerated Solvent Extraction and Pulsed Electric Fields for Valorization of Rainbow Trout (Oncorhynchus mykiss) and Sole (Dover sole) By-Products: …
2021
Fishery by-products are rich in biologically active substances and the use of green and efficient extraction methods to recover these high-added-value compounds is of particular importance. In this study, head, skin and viscera of rainbow trout and sole were used as the target matrices and accelerated solvent extraction (ASE) (45–55 °C, 15 min, pH 5.2–6.8, 103.4 bars) and pulsed electric fields (PEF) (1–3 kV/cm, 123–300 kJ/kg, 15–24 h) were applied as extraction technologies. The results showed that ASE and PEF significantly increased the protein extract efficiency of the fish by-products (p < 0.05) by up to 80%. SDS-PAGE results showed that ASE and PEF treatments changed the molecular size…
The use of utraviolet-visible spectrophotometry in the determination of average properties of nonylphenol ethylene oxide condensates
1983
Ultraviolet spectrophotometry is usd in the determination of average molecular weight (M), average degree of polymerization (X), the hydrophilic-lipophilic balance (HLB) and ethylene oxide percentage of nonylphenol ethylene oxide condensates. The method is based on determination of the absorptivity a, expressed in g lt-1 cm−1, from the absorbances measured at 275 nm for a series of dilutions of an aqeuous ethanolic solution (60:40, v/v/) of a given product, followed by numerical interpolation of this value in the expression a = f(HLB), log a = f(log M), and log a = f(log X). These expressions are obtained from reference samples or samples previously analyzed. The proposed method gives relat…
Fractional dissolution of “solid” unsubstituted cellulose
2000
Activated cellulose (Solucell, DP w = 1400) was extracted stepwise at room temperatures by means of mixed solvents consisting of N,N-dimethylacetamide (DMAc) and LiCl, starting with a salt concentration of 1 wt.-% and increasing it in increments of 1 wt.-% up to 7 wt.-%. Upon the regeneration of the thus obtained cellulose fractions by pouring the solutions dropwise into a large surplus of water, part of the mixed solvent is occluded in the polymer. For that reason the cellulose samples were purified by redissolving them in Ni-tren and by a second precipitation. This process, however, leads to pronounced polymer degradation. For that reason we have used a spinning nozzle to press the extrac…
Improvements of organic aerosol representations and their effects in large-scale atmospheric models
2012
Organics dominate the composition of the atmospheric aerosol, especially in the fine mode, influencing some of its characteristics such as the hygroscopicity, which is of climatic relevance for the Earth system. This study targets an improvement in the description of organic aerosols suitable for large-scale modelling, making use of recent developments based on laboratory and field measurements. In addition to the organic mass and particle number distribution, the proposed method keeps track of the oxidation state of the aerosol based on the OH exposure time, describing some of its chemical characteristics. This study presents the application of the method in a global chemistry climate mode…
Biocompatibility of alginates for grafting: impact of alginate molecular weight.
2003
Optimising microencapsulation technology towards the effective clinical transplantation has created the need for highly biocompatible alginates. Therefore, in this study the biocompatibility of different beads prepared from alginates with varying average molecular weight was examined. In some experiments the beads were covered with a multilayer membrane surrounded by an alginate layer. First of all, we found that beads made of a lower weight average alginate elicted a much stronger fibrotic response compared to beads made of a higher weight average alginate (LV-alginate > MV-alginate). The results were confirmed by the observation that the extent of tissue fibrosis was significantly increas…
Characterization of melt-polymerized polycarbonate: preparative fractionation, branching distribution and simulation
2001
Melt-polymerized bisphenol-A polycarbonate materials characterized by a low degree of branching were fractionated according to molecular weight by the continuous polymer fractionation (CPF) method. The distribution of two types of end-groups and in-chain salicylate moieties arising from thermal rearrangement reactions were assessed across the molecular weight distribution by analysis of the fractions. Experimentally determined branching densities of the fractions agreed well with a molecular simulation based on a random sampling polycondensation model. Both simulation and experiments showed that the branching density increases with molecular weight in the experimentally accessible range. (C…